1. tech3475

    tech3475 Active Member

    Sep 23, 2008
    Likes Received:
    iPhone 4 (Black)
    I just tried upgrading to run rs however it always failed, what are the windows irecovery commands to reset everything including the nand/nor to vanilla so that I can try everything again from fresh.

    For some reason i can get into dfu mode but irecovery wont detect the ipod unless it is in recovery mode.
    ------------------double post merged------------------
    I have managed to install vanilla 2.2.1 using the recovery mode, but DFU doesnt let me install firmware because itunes get stuck at preparing ipod for restore.

    is there a code to reset everything or am i screwed?

Share This Page