Just tried JB with redsn0w 0.9.2 on my IPT3 but failed

Discussion in 'iPod touch' started by ker0r0, Feb 23, 2010.

  1. ker0r0

    ker0r0 New Member

    Joined:
    Feb 17, 2010
    Messages:
    13
    Likes Received:
    0
    Device:
    3G iPod touch
    My IPT3 is 32GB MC version with 3.1.2. After redsn0w 0.92 upload the exploit message and install everything... wait half an hour for the reboot but nothing happen. Power down and restart back to the un-JB OS, no cydia found installed. What should I do next?
  2. _JKK_

    _JKK_ Super Moderator Staff Member

    Joined:
    Jun 8, 2009
    Messages:
    9,514
    Likes Received:
    1,366
    Device:
    iPhone 5S
    You won't be jailbreaking it with that. Just go download blackra1n.
  3. maxam

    maxam Member

    Joined:
    Dec 14, 2009
    Messages:
    371
    Likes Received:
    0
    Device:
    3G iPod touch
    Jailbreak with blackra1n. Its easier and faster.
  4. ker0r0

    ker0r0 New Member

    Joined:
    Feb 17, 2010
    Messages:
    13
    Likes Received:
    0
    Device:
    3G iPod touch
    Finally made it with redsn0w!

    Problem was I wrongly put the iPod into DFU mode, to JB the IPT3 need put it into Recovery Mode, also you have to release the fingers from both power and home button as soon as the connect to iTune screen show up, a few seconds late it will failed - but redsn0w screen still indicate copying RAM disk, etc. that is the confusion part. Do it all over again until you saw a disk display in the IPT3 screen then you will make it!

Share This Page