invisible shield sucks

Discussion in 'Accessories' started by roguewave125, Jan 28, 2008.

  1. roguewave125

    roguewave125 New Member

    Joined:
    Dec 31, 2007
    Messages:
    29
    Likes Received:
    0
    I just got the full body and it sucks a lot. The back was weird with the tabs but i finally got it on. Then the front screen protector never stuck on and the sides wouldnt stay down. and when i took off the back one because this is so bad it took off some of the print on my ipod. i followed the direction exactly but it didnt work. waste of so much money
  2. Tatsu

    Tatsu New Member

    Joined:
    Nov 6, 2007
    Messages:
    363
    Likes Received:
    0
    Device:
    iPod touch
    Aw that sucks, I just installed mine today and I must say I'm pleasantly surprised to actually like it. Don't worry about the back though I think it's etched onto the metal and not printed, it probably just looks like it lifted off the print because its a different surface texture. Maybe if you talk to them they'll give you a refund. good luck with your decision.
  3. saysay

    saysay New Member

    Joined:
    Jan 26, 2008
    Messages:
    313
    Likes Received:
    1
    Some people did have the print peel off. It's etched on but also printed on top of that. If people just put a ton of solution on like they're supposed to, this wouldn't happen.

    I use soapy water and it only takes like 5 minutes to get it perfect. Seriously once you get it on there you just put it where you want and it's 100% clean with no bubbles. You don't even need soap unless you want to slide it around.
  4. Tatsu

    Tatsu New Member

    Joined:
    Nov 6, 2007
    Messages:
    363
    Likes Received:
    0
    Device:
    iPod touch
    oh wow I didn't know it was printed too. Hopefully I won't need to take mine off.
  5. AssLikeThat

    AssLikeThat New Member

    Joined:
    Dec 28, 2007
    Messages:
    236
    Likes Received:
    0
    Device:
    2G iPod touch
    I don't really get the point of Invisible shield for the back.
  6. Tatsu

    Tatsu New Member

    Joined:
    Nov 6, 2007
    Messages:
    363
    Likes Received:
    0
    Device:
    iPod touch
    I think it more for aesthetic protection
  7. antizombie

    antizombie New Member

    Joined:
    Oct 16, 2007
    Messages:
    20
    Likes Received:
    0
    Hmm...I wonder. I mean we all know that Apple uses unscratchable, diamond coated chrome.....
  8. markomite

    markomite New Member

    Joined:
    Jan 21, 2008
    Messages:
    194
    Likes Received:
    1
    Device:
    iPhone 4 (Black)
    HAHA, wordd. they should make harder metal, like steel.
  9. linds

    linds New Member

    Joined:
    Oct 19, 2007
    Messages:
    311
    Likes Received:
    1
    sounds like you weren't patient enough... it takes at least a half hour to apply it. You were supposed to wait for the solution to dry a bit so that it can stick properly to the iPod. Or it could also mean you used too much solution.
  10. linds

    linds New Member

    Joined:
    Oct 19, 2007
    Messages:
    311
    Likes Received:
    1
    Why not? The back is 10x more easier to scratch than the front is.

Share This Page